You are here: Reference for Processing Blocks and Controls > I/O Processing Blocks > Digital Outputs (AES3)

Block Reference

AES3 Output Block (HAL2)

How to Use

A HAL2 (or RAD5's) AES3 Output block represents the AES3 (digital) output signal sent to the AES3 output port on the HAL2 device.

Adding the Block to Your System
  1. Click the Processing tab to open the Processing Workspace.
  2. In the palette area, click the I/O tab.
  3. In the Digital Output Ports (AES3) category, click and drag the appropriate AES3 Output block into your Processing Map.
  4. Wire the appropriate block from your system to the block's Input node.
  5. (Optional) Customize the block name, channel name, and/or input node name by clicking the current name and then typing the custom name in the text box that appears. Click the X to save the name.
Configuring the Block
  • Open the AES3 Output block's properties by double-clicking the block or hovering and clicking the properties icon that appears in the upper right of the block's title bar. From this dialog box, you can do the following:
  • Set the value of the block's output by adjusting the Gain slider or entering a value in the edit box.
  • Provide volume control to end users by linking one or more DR1 or DR3 level controls to the block's Level Gain control. You can limit the range of end user volume control by adjusting the minimum and maximum values at either end of the level control. For example, to give the end user 24 dB of attenuation, set the minimum to -24 dB and the maximum to 0 dB. To change these values, click the minimum or maximum value displayed below the slider. An edit box displays in which you can set the Minimum and Maximum parameter values.
  • Cause the audio to mute completely when dialed to the low end of its range by selecting the Off @ Min checkbox. Using the example range described above, checking Off @ Min provides continuous volume control from 0 dB to -23.9 dB and then mutes the audio completely.
  • Invert signal polarity to change downstream signal polarity.
  • Mute the output channel—without changing the specified Gain value—by selecting the block's Mute checkbox. You can provide end users with control over this Mute parameter by linking the block's Mute control to a Logic In, DR2, or DR3 Toggle control.
  • View meter data for the output signal.

note: The AES3 output resolution is 24-bit and the sample rate is 48 kHz.

User Interface Elements
HAL2 AES3 Output Block

HAL2 AES3 Output Block

UI Element Purpose
Input node Connection point for wiring the input to the AES3 Output block
Digital Output (Channel 1) The output channel connected to the corresponding port on the HAL2 device
HAL2 AES3 Output Block Properties

HAL2 AES3 Output Properties

 
UI Element Purpose

Gain (Manual and Linkable Control)

Gain (both a manual and linkable control) sets the volume of the block's output. Also specified is the volume range with a Minimum and Maximum value. Change the volume by adjusting the slider or entering a dB value in the edit box. Provide end users with control over the volume by linking this Level Control to the Level Control of a DR1 or DR3. Change the range by clicking the Minimum or Maximum value and then typing new values in the edit box that appears. The meter displays signal data for the block output.

Default Gain = 0.0 dB; Default Minimum = -88.0; Default Maximum = 12.0

Off @ Min Checkbox When checked, causes the audio to mute completely when dialed to the low end of its range.
Invert When checked, inverts the signal polarity.
Mute (Manual and Linkable Control) Mute the block's output without changing the Gain value. Provide end users with output mute control by linking this Toggle Control to the Toggle Control of a DR2, DR3, or Logic In port.